Skip to main content

dlink as ap after azteck modem

-you can put aztek modem with real ip and all dhcp relay off
-then configure dlink as AP , turning off dhcp ,pnp,dns relay and obtaigning ip as dhcp.
-then configure real ip on all devices manually .
-in this case you are using WAN connection with modem .
-------
in second case you can use LAN to LAN connection with modem and dlink and using modem dhcp by putting dlink in ap mode turining of dhcp, pnp in dlink.

rememeber this configuration is with DLINK 500 and Aztek single Lan port DSL modem.Dlink has ethernet port to connect ISP.

better to use dsl wireless modem

this configuration was done to use real ip in the netowrk ,
Labels:

Comments

Post a Comment

Popular posts from this blog

LSA types. Type Code

LSA types. Type Code Description 1 Router LSA 2 Network LSA 3 Network Summary LSA 4 ASBR Summary LSA 5 AS External LSA 6 Group Membership LSA 7 NSSA External LSA 8 External Attributes LSA 9 Opaque LSA (link-local scope) 10 Opaque LSA (area-local scope) 11 Opaque LSA (AS scope)
Post a Comment
Read more

OSPF STUB , NSSA AREAs

IP Routing How Does OSPF Generate Default Routes? Document ID: 13692 Contents Introduction Before You Begin Conventions Prerequisites Components Used Types of OSPF Areas Normal Areas Stub and Totally Stub Areas NSSAs Related Information Introduction The way that Open Shortest Path First (OSPF) generates and advertises default routes (0.0.0.0) varies depending on the type of area the default route is being injected into. In this document, we cover normal areas, stub/totally stub areas and not-so-stubby areas (NSSAs). Before You Begin Conventions For more information on document conventions, refer to the Cisco Technical Tips Conventions . Prerequisites There are no specific prerequisites for this document. Components Used This document is not restricted to specific software and hardware versions. Types of OSPF Areas Normal Areas: These areas can either be standard areas or transit (backbone) areas. Standard areas are defined as ...
Post a Comment
Read more

IP prefix-list

IP prefix-list ip prefix-list provides the most powerful prefix based filtering mechanism Here is a quick little tutorial on Prefix-lists for you. A normal access-list CANNOT check the subnet mask of a network. It can only check bits to make sure they match, nothing more. A prefix-list has an advantage over an access-list in that it CAN check BOTH bits and subnet mask - both would have to match for the network to be either permitted or denied. For checking bits a prefix list ALWAYS goes from left to right and CANNOT skip any bits. A basic example would be this: 172.16.8.0/24 If there is only a / after the network (no le or ge) then the number after the / is BOTH bits checked and subnet mask. So in this case it will check the 24 bits from left to right (won't care about the last 8 bits) AND it will make sure that it has a 24 bit mask. BOTH the 24 bits checked and the 24 bit subnet mask must match for the network to be permitted or denied. No we can do a range of subn...
Post a Comment
Read more